How To Change Sensor On Outdoor Light

Pull out the entire fixture and take out any electrical tape found in the wires inside.

How to change sensor on outdoor light. You ll want to make sure the detection field is not too wide or too low causing the bulbs to illuminate for passing cars pedestrians stray animals or other general movement. Make sure the sensor is not blocked before. Get your new fixture and place it on. Do the same thing with the black wires securing the wires together with a wire nut.

Take out the bulb found inside. Using needle nosed pliers to get started unscrew the sensor. Next place your replacement light sensor over the hole. Connect the two white wires the one from the wall with the one on the back of the motion detector.

After installing your new outdoor security lights it s important to properly set up and adjust the motion detector settings otherwise your flood lights may not operate at their full potential. If you do not need a ladder to reach your light it is probably too low since a burglar. Attach the two wires together with a wire nut. Place the new motion detector in the right position.

You can find them below. How to adjust the sensor on an outdoor security light step 1. Locate the light sensor and disconnect its wires from the wires attached to the wall. Remove any dust or dirt that could be interfering with the sensor.

Turn off the power. Remove the light bulb cover.