How To Fix A Gate Post Into The Ground

Cut a piece of 1 by 4 inch or 2 by 4 inch lumber to twice the length of the fence post diameter.

How to fix a gate post into the ground. This piece called a deadman post support helps anchor the post in the ground and is especially. The problem must be pretty common because someone has already packaged and marketed a repair kit for exactly that purpose. The metal spike is driven into the ground with a sledgehammer. It s called a gate repair kit or turnbuckle kit and it consists of a cable with corner mounting brackets and a turnbuckle.

Putting posts in the ground is an important step in building a fence and pouring cement into the holes will keep your posts sturdy and protected. After digging the hole all you need to do is mix your cement and let it set. It provides an inexpensive and convenient way to erect a fence in a short amount of time. With posts that are sunk into the ground the bigger the post size the better however with wall fixing posts the narrower to an extent the better as the gate post or fixing stile is only as strong as the method of fixing to the wall if you opt for something like a 150mm square post then you ve got a lot of timber to get through before.

The arbor s four posts do not provide extra space to sink posts deeply into the ground with concrete we will need to dig holes about 1 foot deep mix concrete in a wheel barrow and pour it into the holes. Dig a hole about 1 foot deep. After your post has soaked thoroughly use a brush to apply a thick layer of preservative on the bottom 2 feet. In terms of how deep our fence post holes need to be again the rule of thumb is to allow at least 25 of the posts length to be in the ground.

You have three choices of posts for sinking into the ground either tanalised softwood posts available from most builders merchants sawn green oak posts more of a specialised product and available from saw mills and timber merchants etc and steel posts. The metal box that is attached at the top holds the base of the wood fence post. A post spike is made of heavy metal and is about 24 to 30 inches long so that it can get a good grip in the ground. Make sure to let the post dry overnight before setting it into the ground.

To install a somewhat flimsy pre fabricated wood arbor into the ground to ensure stability. The metal spikes are simply driven into the ground with a sledge hammer or mallet but it is really advisable to put a driving block into the fence post spike first shown in the image below. To treat your post soak the bottom foot for 15 to 20 minutes in a large bucket of wood preservative containing copper napthenate. A 6 foot high fence should have an 8 foot post with at least 2 feet in the ground a 5 foot fence should have a 6 foot 6 inch post with 1 foot 6 inches in the ground etc.

Sinking gate posts into the ground.