How To Install A Vinyl Picket Fence On A Slope

There are limitations with steep angles.

How to install a vinyl picket fence on a slope. Tip typical spacing for wood and metal fences is 8 feet but if you re using the step method on a steep slope you ll probably have to reduce the spacing to avoid. Installing a vinyl fence on a slope requires the use of the step method. We recommend allowing a minimum 2 clearance between the bottom of the panel and the ground. When installing a fence on a slope that is greater than 10 degrees it is necessary to enlarge the holes in the posts and rails.

When installing your fence or gate we recommend installing 1 post and section at a time. If you use the slope method to install the jiminy picket nervous nelly or the peeping tom fence you may need to enlarge the holes on the bottom of the top fence rail. After you are done with the installation of the planks you can trim off the posts that are too high above the planks. Assemble the fence rails and the posts.

Moreover even when the slope is gentle raking creates a fair amount of extra work when installing a chain link fence because you have to cut the ends of the metal mesh at an angle. Refer to the maximum slope chart for various fence styles. If they are not then be assured that you have successfully installed the fence on a slope. Use the rack method to install the fence on a gentle slope and install the fence on a slope steeper than 35 degrees using the step method.

The fence gradually steps up the slope so that each bay section is the same length and the rails are level instead of parallel to the slope. Install the first picket at one side of the gate and work around the fence to the other side. Use a level to keep each picket vertical and keep the tops of the pickets a uniform distance from the. If you slope is greater than 15 degrees or so talk to your fence consultant about potential solutions.