How To Open Garage Door With Code

Depress the button on the garage door motor once again until the light comes back on.

How to open garage door with code. Depress the button on the side of the motor and hold down. This will remove the old code from the garage door openers memory. Release the button and try again if lights don t blink after a few seconds. Press and release the learn button on your first garage door opener motor unit.

Since the doors used the same signal and code any remote could open any door. Let go of the button when the light next to it goes out. Step 1 flip open the cover of the keypad and enter your four digit garage door code. The garage door then opens.

Press a different button on the remote to complete programming. If the tag is on the authorized list the arduino will pull a pin high to provide 5v to close a relay. Step 2 immediately press and hold the button. When the relay closes it connects the terminals of the garage door signal contacts.

Release the button when. Choose a remote button and hold it down until the opener lights blink. Press the learn button located on the side of the motor and hold it down. The arduino then reads the code from the serial connection and compares it to a list of authorized rfid codes.