How To Put Sliding Glass Shower Door Back On Track

Sometimes one roller falls out of the track and the bottom edge of the door skids along the lower rail.

How to put sliding glass shower door back on track. Hold the shower guide above the bottom of the track as much as you can while you slide it onto the edges of the shower doors. Lift the shower door up at an angle and set. First make sure the rollers on both doors are riding on the tracks inside the upper rail. Slide the shower doors back to one side and place the guide in the middle area of the shower track.

Angle the bottom of the door toward you while you let it down and the wheels should hook right onto the track. Release the door and let it swing gently back to the vertical position. There are a screw at the inside top of the track. Once the tracks are clean and free of dust and hair you are ready to put the sliding glass door back in place.

Take a razor knife and cut the caulking if there is any. Again using the screwdriver loosen the screw holding the roller and adjust it in the slanted slot it is attached to. There should be rollers at the top of the shower door. Step 4 lift the sliding glass door up and set the bottom edge of it into the bottom track.

Raise or lower the doors and test the adjustment. Try these 4 ways to get sliding door back on track mike mcclintock special to tribune newspapers when glass sliding doors bog down in their tracks and need to be tugged open and closed there are. On the shower door frame there is a small rail or track or channel that the rollers sit on top of. Reinstall the sliding panel by inserting the top of the panel into the top track and lifting the door onto the track.

Ideally you will want to get the doors close to the halfway point on the guide so they are secure in it. Insert the door s wheels into the double track inside the upper door jamb lifting it as far as it will go. In that case you only have to lift the door and guide the roller back onto the track. Spray the tracks with an all purpose cleanser and wipe gently with a cloth or paper towel.

Unscrew them the should be about1 4 inch long.