How To Trim The Bottom Of A Door With A Hand Saw

To prevent splintering score the cut line with a razor knife before sawing off the door.

How to trim the bottom of a door with a hand saw. I know a circular saw would be best but i don t have one. Draw a straight line along the bottom of the door on top of the masking tape using a straight edge or framing square and a pencil. Hold the saw against the cutting guide and check the position of the blade s teeth. If so would you recommend a hardwood or softwood cutting jigsaw blade.

Measure across top of door and on the inside and add 3 8 inch to the measurement. It is used predominantly for laminate wood and cork flooring installations. Just draw a line round the bottom of the door about 15mm and cut it off died easy. Let the blade pull your saw through the cut and gently guide the base plate along the straight edge.

I m looking to trim off about 5mm from either sides as well as top and bottom of my 6panel internal bedroom door and i m wondering if a jigsaw would be okay. The scored line will stop the splintering. Keep both of your hands on top of the saw s handle to steady it as you cut. Once you ve scored the door clamp a straight edge to it at the proper distance from the door edge.

When trimming a hollow core door take less than an inch off each side to avoid cutting into the void beyond the frame. Jamb saw undercut doors casing trim. Oh and just find out where your local a and e is. Maybe replace an old door and it just won t fit.

If you can use a hand saw that s your easiest way to do it. The bottom side of the door won t splinter because the saw teeth cut up into the wood. A jamb saw is a mechanical gizmo designed specifically for removing the bottom of door casings so flooring can slide under thus providing a nice clean appearance after the floor is installed. Lightly sand all the edges along the new door bottom to soften them then rehang the door.

Diycrew hrvdiy renovision need to resize a door that gets stuck. Then push the saw forward until the teeth hit the side of your door. At the end of the cut drive the saw all through the edge of the door before releasing the trigger. Step 2 cut the 45 degree angle on both sides from the short to short direction.

The veneer face on hollow core doors also tends to splinter easily. Need a creative solution.