How To Adjust Tension On Garage Door Springs
A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.
How to adjust tension on garage door springs. If the tension is too loose the springs that help lift the. The springs are located at the top inside part of the garage door. One end of the spring is connected to the garage door track or frame. You must release the tension on the garage door springs before attempting adjustment or replacement.
To adjust torsion spring tension the door is locked in the down position. Before you start actually adjusting the door push it up as far as possible. With locking pliers clamped on the torsion tube winding bars are used to wind the springs tighter to increase tension. This can make the other parts of the garage door last a much longer time.
The other is attached to a pulley connected to the cable. When two springs are used both sides should be adjusted the same. You will have to adjust the tension on that side. How to adjust garage door tension.
Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel. Release the tension on the springs by opening your garage door all the way and securing it in place with a c clamp. If you notice a gap on one side it means that one of the springs is putting more force on the door than the other. Tension is reduced by removing turns.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track. Then disconnect any existing safety cables and remove them away from the door springs. Garage door springs offset the weight of the door and allow it to open and close with ease. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments you may need to have someone helping you to adjust the torsion spring because it can be potentially dangerous.
You need proper tension on a garage door to operate the door by hand or with an automatic opener. Adjustments should be made in 1 4 turn increments.