How To Hang Christmas Lights On Stucco Walls

Test your light string to make sure there are no missing or burned out bulbs.

How to hang christmas lights on stucco walls. Slide the prongs under a shingle and leave the side with the whole sticking up into the air. Gutter hooks allow homeowners to attach christmas lights securely from all types of drain systems. Place the ladder in the location where your string lights will end and climb the ladder with your lights and glue gun. To position the lights slide a bulb into the hole to hold it in place.

Again hold it firmly in place for 30 seconds to ensure a proper seal. Typically made out of plastic the hooks simply slide and latch into place on the gutter. Command strips may not stick to stucco it may be too rough. Fortunately you can hang your christmas halloween or other decorative lights quickly and easily by following a few simple steps.

You can do this indoors by plugging the lights into an electric outlet. Drive the masonry screws into the anchors with a power screwdriver. Hanging lights outdoors is a time honored holiday tradition. Press your christmas light against your home.

Opt for shingle tabs to position the lights on top of your roof. If you don t think it is command actually has hooks made for hanging christmas lights just saw them yesterday at home depot when we were looking for some other fasteners for coax cable. Pull the trigger directing a glob of glue onto the cord and wall. Remove the cover on the remaining side of the tape and press your christmas light against the stucco wall.

Continue attaching double sided tape to your christmas lights and pressing the lights to the wall. Replace bulbs as needed then unplug the lights. Place the nozzle of the glue gun close to the light cord being careful not to touch it. Hold the end of the string lights against the wall with one hand.

However stucco surfaces can make the job difficult at times. Push a cement wall anchor into each hole.