How To Install Wall Anchors In Plaster

To install the anchor drill a hole in the wall that s deeper than the anchor is long then slide the expansion anchor into the hole.

How to install wall anchors in plaster. Set the anchor in place then drive a screw in. Drill pilot holes through the wall with a masonry drill bit. Step 5 install the screws in the wall anchors. With molly bolts and plastic wall anchors all you need to do is press the anchor into the hole.

After use you can easily unscrew the screws and anchors for re use later. With molly bolts and plastic anchors the screws will be slightly smaller than the anchor and the anchor will automatically expand as the screw progresses in the anchor providing support to the wall. This is the rough placement guide for the handrail. Allow the drill bit to do the work.

I discovered these. You can then the screw can easily insert into the anchor. Don t press too hard. Finish by screwing the support screw into the anchor but remember to leave enough of the screw.

To install the additional anchors. Measure from the top of the stair treads up the wall to a height of 34 to 36 inches and make a light pencil mark on the wall at each measurement. Predrill a hole for the second and third if necessary and install that screw. Drill a hole large enough to pass the toggle hinge.

Installing a toggle anchor remove the toggle and install any wall brackets before inserting it into the wall. Fit a power drill with a matching drill bit. Then drill straight through each of the marks and into the wood studs behind them. Place the tip of the bit against the center of the masking tape x hold the drill steady and drill straight into the plaster.

Measure the height you want the shelf to be and pre drill one hole there. Pinch the toggle arms together and push the whole assembly into the hole pushing on the bolt head completely flat with the wall until the toggle springs open inside.