How To Install Refrigerator Water Line Valve

You should find the shut off valve when you arrive at the source.

How to install refrigerator water line valve. Ensure the valves inlets. Just run the tubing to the floor near the water line hookup on the fridge. Then attach the tubing to the back of the cabinets every 2 to 4 ft. Part 3 of 3.

Use either a self tap saddle valve or a tee stop valve. Tapping a sink without a valve. Don t use a saddle tee valve for an icemaker or water filter. If you need a water line connection to your refrigerator to run your filtered water or ice maker here some simple steps to do the job.

Refrigerator water line to the stop valve with a compression joint. Pull the refrigerator away from the wall far enough so you can access the water line connection and work on the back of the refrigerator. Remove the parts from the packaging. Running a water line to a refrigerator to supply its ice maker and drinking water dispenser has never been easier.

If your sink does not have a shut off valve you will have to tap the line through the sink s piping and install a valve for the refrigerator water line. Prior to shutting off the valve it s a good idea to turn off the icemaker. The icemaker kit will come with a water line a coupler a new valve and a few brass parts such as nuts and ferrules. Now there are convenient and less kink able 1 4 inch.

1 close the cold water shut off valve leading to the kitchen sink. Pull out the refrigerator and follow the water supply line from the fridge to the source. 2 disconnect the copper cold water pipe from the supply line that runs up to the faucet the water line to the refrigerator should have its own shut off valve this shut off valve is usually located under the kitchen sink in the basement in a crawl. Install one end of the line on the refrigerator by threading the line through the nut adding one of the brass ferrules to the line and screwing the nut in place on the refrigerator valve.

At one time this was typically done with 1 4 inch bendable copper tubing that was snaked from the refrigerator to the nearest source of water and tapped into the water line using a saddle valve or other type of fitting. Once you locate the refrigerator water line shut off valve pause. Next attach the 1 4 in. Place a towel under the water valve assembly to catch water.

Once you re outside the last cabinet don t attach any clamps.